Table of Contents
Advertisement
Chapter 4: Web-Based Management
Figure 4-33: STP Port State Transitions
You can modify each port state by using management software. When you
enable STP, every port on every switch in the network goes through the blocking
state and then transitions through the states of listening and learning at power
up. If properly configured, each port stabilizes to the forwarding or blocking state.
No packets (except BPDUs) are forwarded from, or received by, STP enabled
ports until the forwarding state is enabled for that port.
STP Parameters
STP Operation Levels
The Switch allows for two levels of operation: the switch level and the port level.
The switch level forms a spanning tree consisting of links between one or more
switches. The port level constructs a spanning tree consisting of groups of one or
more ports. The STP operates in much the same way for both levels.
76
GE-DS-242-PoE Managed Ethernet Switch User Manual
Advertisement
Table of Contents
