Illustration Of Stp - Interlogix GE-DS-242-PoE User Manual

Managed ethernet switch
Table of Contents

Advertisement

Chapter 4: Web-Based Management
Default Spanning-Tree Configuration
Feature
Enable state
Port priority
Port cost
Bridge Priority
The Hello Time cannot be longer than the Max. Age. Otherwise, a
NOTE:
configuration error will occur.
Observe the following formulas when setting the above parameters:
 Max. Age _ 2 x (Forward Delay - 1 second)
 Max. Age _ 2 x (Hello Time + 1 second)

Illustration of STP

A simple illustration of three switches connected in a loop is depicted in the
below diagram. In this example, you can anticipate some major network
problems if the STP assistance is not applied.
If switch A broadcasts a packet to switch B, switch B will broadcast it to switch C,
and switch C will broadcast it to back to switch A and so on. The broadcast
packet will be passed indefinitely in a loop, potentially causing a network failure.
In this example, STP breaks the loop by blocking the connection between switch
B and C. The decision to block a particular connection is based on the STP
calculation of the most current Bridge and Port settings.
Now, if switch A broadcasts a packet to switch C, then switch C will drop the
packet at port 2 and the broadcast will end there. Setting-up STP using values
other than the defaults, can be complex. Therefore, you are advised to keep the
default factory settings and STP will automatically assign root bridges/ports and
block loop connections. Influencing STP to choose a particular switch as the root
bridge using the Priority setting, or influencing STP to choose a particular port to
block using the Port Priority and Port Cost settings is, however, relatively straight
forward.
78
Default Value
STP disabled for all ports
128
0
32,768
GE-DS-242-PoE Managed Ethernet Switch User Manual

Advertisement

Table of Contents
loading

Table of Contents