Intermec 3440 User Manual page 122

3440 Bar Code Label Printer User's Manual
To make field zero a bar code field, you have to delete human-readable
field 0 and then define bar code field 0. To do this, you must create a
temporary field (L1) before you delete human-readable field zero (H0):
<STX><ESC>P;E1;F1;L1;D0;B0;D1;<ETX>
This table describes each command in the string:
Command
<ESC>P;
E1;
F1;
L1;
D0;
B0;
D1;
When numbering the fields in a format, it is important to remember to give
every field a different number. Never use a field number more than once.
You can have up to 200 fields numbering from 0 to 199. The importance of
field numbering comes into play when you are in Print mode and are
entering data into the label format. At this point, you can only identify the
fields by a number, not by what type of field.
Also keep in mind that you enter data into fields according to their numeric
value if you use a <CR> to separate the data. In other words, the first string
of data you enter goes into the lowest numbered field, the second string of
data you enter goes into the next lowest numbered field, and so on.
5-20
*1233*
Definition
Enters Program mode
Erases format 1
Creates format 1
Creates line field (temporary field)
Deletes field zero
Creates bar code field zero
Deletes field 1
FranklinGothic