Editing Existing Fields - Intermec 3440 User Manual

*1233*

Editing Existing Fields

If you make a mistake in a label format, you may not have to download the
entire format again depending on the severity of the mistake. You can
change a specific field in a format by sending a command in Program mode.
You can modify just the incorrect format field(s) instead of having to
download the entire format again.
The printer uses a field pointer to point to the field that you are going to
modify when the printer is in Program mode. The pointer continues to point
to the most recently selected field until you select a different format or field.
Use the following format as an example. Assume you have downloaded the
following format to the printer:
Commands
<STX><ESC>C1<ETX>
<STX><ESC>P<ETX>
<STX>E3;F3;<ETX>
<STX>H0;o160,200;f0;c0;d0,16;h1;w1;<ETX>
<STX>H1;o160,240;f0;c0;d0,16;h1;w1;<ETX>
<STX>H2;o160,300;f0;c2;d0,14;h1;w1;<ETX>
<STX>H3;o160,380;f0;c2;d0,16;h1;w1;<ETX>
<STX>B4;o160,0;f0;c0,1;h100;w2;d0,11;i0;p@;<ETX>
<STX>R;<ETX>
Designing Labels and Using IPL Commands
FranklinGothic
Description
Selects 2.5 mil Advanced mode
Enters Program mode
Erases format 3, Create format 3
Creates field H0
Creates field H1
Creates field H2
Creates field H3
Creates field B3
Saves and exits to Print mode
5
5-21