Dark Adjust, Set; End-Of-Print Skip Distance, Set - Intermec 3440 User Manual

HelvC

Dark Adjust, Set

Purpose: Sets the dark adjust command. This command controls the print darkness
on the labels.
n = 0
Default:
Syntax:
<SI>d n
The range for n is from -10 to +10 (in increments of one). The darkest setting
is +10 and the lightest setting is -10.
Notes: This command becomes effective upon execution.

End-of-Print Skip Distance, Set

Purpose: Sets the end-of-print skip distance. This distance is a value in 5 mil
increments that the label advances after printing or when you pause
printing.
Default: n = 0
n = 123
Syntax:
<SI>D n
n must be a number from 0 to 9999 in 5 mil increments.
This command is effective upon execution.
Notes:
To advance the label out to the tear bar in label stock mode, set n to 108.
If you enter a value for n, it applies to both continuous mode and label stock
mode, regardless of the mode in which you enter the value.
Entering the <SI>D command without setting any parameters returns the
printer to the default.
This command is ineffective in self-strip applications.
C o d e 3 9
N
ugFont
Label stock mode
Continuous stock mode
Configuration Commands
*1233*
FG 9pt Italic
6
6-41