Data Shift - International Characters; Emulation Mode, Enter - Intermec 3440 User Manual

3440 Bar Code Label Printer User's Manual
Data Shift – – International Characters
Purpose: Allows you to enter command characters as data.
Syntax:
<SUB>
Notes: In 86XX Emulation mode, this command shifts the next character (if not a
control character) into the upper character bank (setting the eighth bit to 1)
to print international characters.
This command allows you to enter command characters as data instead of
commands in both Advanced and 86XX Emulation mode.

Emulation Mode, Enter

Purpose: Instructs the printer to operate in Emulation mode.
Default: n = 0
Syntax:
<ESC>c n
n = 0
n = 1
Notes: The field pointer designates the first field in format 0.
You disable the page select command and lose all previously host-entered
data.
You can also set this command by using Test and Service DIP switch
settings. See Chapter 8, "Using Test and Service Mode," for more
information.
6-24
*1233*
Specifies 10 mil (0.010 inch) dot size.
Specifies emulation with 15 mil (0.015 inch) dot size for bar codes
only (other fields are in the 10 mil dot size).
FranklinGothic
*1233*
FG 9pt Italic