Using Forms Adjust - Intermec 3440 User Manual

1233*
FranklinGothic Helv Cond

Using Forms Adjust

If your label prints too close to one edge, you can reposition it by using the
X forms adjust and Y forms adjust features. The X forms adjust controls the
position of the printing area along the length of the label. The Y forms adjust
controls the position of the printing area along the width of the label.
The following figure shows the default X and Y origins. You can control the
default X origin (top of form) with software command <SI>F or with the
Test and Service DIP switches. See Chapter 6 for the Top of Form, Set
software command and its default. You can control the default Y origin with
the DIP switches only.
Origin (Ø,Ø)
-X
*FORMAT*
Y
+Y
Leading
edge
Direction of media from printer
The default X origin is 0.10 inch (20 dot increments) from the leading edge
of the label. You can move the X origin forward or back 30 increments,
where each increment is 5 mil.
The default Y origin is 0.00 inch from the edge of the label. You can move
the Y origin down 30 increments, where each increment is 5 mil.
Using Test and Service Mode
+X
*FORMAT*
8
3440U.053
8-15