Configuration Commands - Intermec 3440 User Manual

6
C o d e 3 9

Configuration Commands

N
HelvC ugFont
*1233*
FG 9pt Italic
Configuration Commands
Configuration commands, like Print mode commands, are effective when
the 3440 is in Print mode. You should use configuration commands for the
following tasks:
• Το set parameters for configuration features
• To enable or disable options
Some configuration commands only take effect when you reset the printer
or cycle the power. Some commands are effective immediately. If you need
to reset the printer, use the warm boot command (<BS>). The printer
performs the reset after it executes all previous commands. The warm boot
command contrasts with the <DLE> reset command, which executes
immediately after the printer receives it (even if other commands are
waiting to execute). The command string to enter Print mode from Program
mode is:
<STX>R<ETX>
Note: You must precede each string of commands with the start of message
character <STX> and follow it with the end of message character <ETX>. The
printer terminates a configuration command when it receives the next command in
the message.
The following command descriptions explain the configuration commands
that are effective when the printer is in Print mode. The list of command
descriptions is in alphabetical order.
6-37