Konica Minolta bizhub C35P Service Manual page 185

13. MALFUNCTION CODE
LCD1 LCD2/LCD3
(service (error descrip-
call ID) tion)
0062 TRAY3 FEED
MOT
0094 XFER
DETACH 2
0096 XFER
DETACH 1
0300 POLYGON
MOT
0310 LASER
ERROR
0500 FUSER
ERROR
0502 TERMISTOR1 Thermistor open-cir-
0503 TERMISTOR2 Thermistor resistance
0510 FUSER
ERROR
0520 FUSER
ERROR
150
Item
Tray 3 media feed • The motor lock signal remains HIGH for a given
motor malfunction
2nd image transfer • The IDC sensor does not come into the condi-
pressure / retraction
failure
• The IDC sensor does not come into the condi-
1st image transfer • The 1st transfer release sensor is not activated
pressure / retraction
failure
• The 1st transfer release sensor is not deacti-
Polygon motor • The polygon motor does not rotate evenly even
malfunction
• The motor lock signal remains HIGH for a given
Laser malfunction • The SOS signal is not detected within a given
Heating roller warm-up • The thermistor /1 does not detect the specified
failure
• The temperature detected by the thermistor/1
cuit failure
• The difference between the temperature
failure
Abnormally low heat- • The temperature detected by the thermistor /1
ing roller temperature
Abnormally high heat- • The temperature detected by the thermistor /1
ing roller temperature
• The heater lamp remains ON for a given period
Field Service Ver. 1.0 May 2010
Detection timing
period of consecutive time while the media feed
motor is being rotated.
tion where the level detection is available
(retracted position = IDC sensor shutter is open)
within a given period of time after the 2nd trans-
fer release solenoid has turned ON.
tion where the level detection is not available
(pressed position = IDC sensor shutter is
closed) within a given period of time after the
2nd transfer release solenoid has turned ON.
(retracted position) within a given period of time
after the 1st transfer release solenoid has turned
ON.
vated (pressed position) within a given period of
time after the 1st transfer release solenoid has
turned ON.
after the lapse of a given period of time after it
has been started.
period of consecutive time while the polygon
motor is being rotated.
period of time after the output of the laser has
been started.
temperature and the warm-up cycle is not com-
pleted even after the lapse of a given period of
time after the cycle has been started.
does not reach a predetermined level even after
the lapse of a given period time after the warm-
up cycle has been started.
detected by thermistor/1 and that detected by
thermistor/2 exceeds a predetermined value.
remains lower than the specified value for a
given period of time or longer.
remains higher than the specified value for a
given period of time or longer.
of time or longer.