Starting/Exiting; Starting Procedure - Konica Minolta bizhub C35P Service Manual

10. SERVICE MODE

10.2 Starting/Exiting

10.2.1

Starting procedure

NOTE
• Make sure not to reveal the password of the service menu to any unauthorized per-
son.
A. Procedure 1
1. Display [SERVICE MENU] on the menu screen and press the Menu/Select key.
2. [ENTER PASSWORD] message is displayed.
3. Set first digit of password with the up key /down key
4. Repeat the above procedures to set up to seventh digit of password.
Enter "KMBC35P" for service password.
NOTE
• The service password needs to correspond to the product name.
5. Press the Menu/Select key.
B. Procedure 2
1. Turn the power switch ON while pressing the up key
power switch OFF.
NOTE
• Continue to press the up key
sage appears on the control panel.
2. When initializing is complete, the service menu appears.
NOTE
• Password authentication is not required before starting to operate the service
menu, however, once the service menu is closed, you need to enter the password
to display the service menu again.
C. Procedure 3
• If a service call message is on the display, perform the following steps, since the ordinary
procedure may not be good for entering the service menu.
1. With the service call message on the display, hold down the Menu/Select key for 5 sec.
or more.
2. Set first digit of password with the up key /down key
3. Repeat the above procedures to set up to seventh digit of password.
Enter "KMBC35P" for service password.
Only the following menu items are, however, available if the service menu is accessed
through the above steps.
SERIAL NUMBER, FIRMWARE VERSION, RESTORE PASSWORD, BK CLEAR,FIRM-
WARE UPDATE, CS REMOTE CARE, SOFT SWITH, ENGINE DIPSW, FUNCTION
D. Exiting procedure
• Press the Cancel key.
100
and the Menu/Select key at the
and the Menu/Select key until "INITIALIZING" mes-
Field Service Ver. 1.0 May 2010
and press the right key .
and press the right key .