Clutch Hose Removal And Installation - Suzuki GSX1300R Manual

6) Connect a clear hose to the air bleeder valve and
insert the other end of hose into a receptacle.
7) Loosen the air bleeder valve and pump the clutch
lever until old clutch fluid flows out of the clutch fluid
circuit.
8) Close the air bleeder valve (2) and disconnect the
hose.
Tightening torque
Air bleeder valve (Clutch) (a): 6 N·m (0.6 kgf-m,
4.5 lb-ft)
I815H1530003-01
I815H1530004-01
2
(a)
I815H1530007-01
9) Fill the reservoir with brake fluid to the upper mark
"A" of the reservoir.
10) Reinstall the removed parts.

Clutch Hose Removal and Installation

Removal
1) Remove the left side cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)".
3) Drain clutch fluid. Refer to "Clutch Fluid
Replacement (Page 5C-4)".
4) Remove the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
Diagram (Page 5C-2)".
Installation
1) Install the clutch hose as shown in the clutch hose
routing diagram. Refer to "Clutch Hose Routing
Diagram (Page 5C-2)".
2) Bleed air from the clutch system. Refer to "Air
Bleeding from Clutch Fluid Circuit (Page 5C-4)".
3) Reinstall the removed parts.
Clutch: 5C-5
"A"
I815H1530008-01
B815H25306006