Warning Function - Omron SYSDRIVE RX Series User Manual

5-2 Warning Function

•The following table shows the details of warning display and parameter correction.
Warning display
001/201 Frequency upper limit A061/A261
002/202 Frequency lower limit A062/A262
004/204/304 Base frequency A003/A203/A303
Output frequency F001, Multi-step speed reference 0 A020/
005/205/305
A220/A320
006/206/306 Multi-step speeds 1 to 15 A021 to A035
009 Orientation speed setting P015
012/212 Frequency lower limit A062/A262
Output frequency F001, Multi-step speed reference 0 A020/
015/215
*2
A220
016/216 Multi-step speeds 1 to 15 A021 to A035
019
Frequency upper limit A061/A261
021/221
Output frequency F001, Multi-step speed reference 0 A020/
025/225
A220/A320
031/231 Frequency upper limit A061/A261
032/232 Frequency lower limit A062/A262
Output frequency F001, Multi-step speed reference 0 A020/
035/235/335
A220/A320
036 Multi-step speeds 1 to 15 A021 to A035
037 Jogging frequency A038
Output frequency F001, Multi-step speed reference 0 A020/
085/285/385
A220/A320
086 Multi-step speeds 1 to 15 A021 to A035
*1. In this case, the base frequency is rewritten when correcting parameters. Change the data to a correct value
if a warning occurs. Otherwise, the motor may burn out depending on the value.
*2. Checks even if the frequency reference selection (A001) is set other than to the Digital Operator (02).
*3. The jump frequency is rewritten into the value of the subtraction of the jump width (lower limit) from the jump
frequency.
Target code
*1
*2
*2
*2
*2
5-2 Warning Function
Condition Base code
>
>
>
Maximum frequency
A004/A204/A304
>
>
>
>
Frequency upper limit
>
A061/A261
>
Orientation speed
<
P015
<
Frequency lower limit
A062/A262
<
<
<
Starting frequency
<
b082
<
<
Jump frequency 1/2/3
< >
± Jump width
A063 ± A064
A065 ± A066
< >
*3
A067 ± A068
5
5-10