Omron SYSDRIVE RX Series User Manual page 67

5. Change the 1st digit of the extended function code.
ak0k2k1
Press or
(8 times) (2 times)
ak0k2k9
Press .
("9" is entered.)
6. The extended function code setting is complete.
ak0k2k9
7. Press the Mode key to display the data. Use the Increment/Decrement keys to change the data
and press the Enter key to set it.
The data can be set in the same procedure as 1 to 6.
1 This operation is available even if code "d001" is not displayed.
*
2 If pressing the Mode key while each digit is blinking, the display returns the status for the 1-digit
*
higher entry.
* 3 If pressing the Mode key while the 4th digit on the left is blinking, the values under entry are
canceled and the display returns to the status before pressing the Increment and Decrement
keys simultaneously in 1.
4 To change the data, be sure to press the Mode key.
*
• "1" of the 1st digit blinks.
("A029" is displayed).
• "9" of the 1st digit blinks.
*2
• The code display "A029" selection is complete.
Note: "A" of the 4th digit on the left starts to blink
again when entering codes which have not
been selected for display or codes not on the
list.
Refer to
Screen Selection (Initial Screen at Power-ON)"
(page 4-56)
Setting Function" (page 4-57)
Parameter List" to check the code, and enter
again.
* 4
* 3 * 4
3-6 Parameter Transition
"Display Selection" (page 4-53)
"User Parameter Automatic
,
, and "Appendix
3
, "Initial
3-18