Omron SYSDRIVE RX Series User Manual page 59

Display System and Key Sequence of Each Code
• This section explains the examples of typical operation (Basic display, Complete display) and the
extended function mode U as a special operation.
This operation can be performed when other display modes are selected.
The display indicates the setting of "b038" when the power is turned on. For details, refer to
"Initial Screen Selection (Initial Screen at Power-ON)" (page 4-56).
When "b038 = 01" (factory default),
Press the Mode key to display
Note: The Digital Operator display varies depending on the settings of display selection "b037", ini-
tial screen selection "b038", and user parameter automatic setting function selection "b039".
For details, refer to "Display Selection" (page 4-53), "Initial Screen Selection (Initial Screen
at Power-ON)" (page 4-56), "User Parameter Automatic Setting Function" (page 4-57).
Item
Display selection
Initial screen
selection
(Power On)
User parameter
automatic setting
function selection
*Not displayed by factory default.
* To return the display to
the following procedures.
• Hold down the Mode key for 3 seconds or more to display
Press the Mode key to display
* shows the status during stop. Displays the output frequency of the Inverter during
0.00
operation.
3-4 Part Names and Descriptions of the Digital Operator
Name
Increment key Changes the mode.
Also, increases the set value of each function.
Decrement key Changes the mode.
Also, decreases the set value of each function.
dk0k0k1
Function code
b037
b038 *
b039 *
or
dk0k0k1
dk0k0k1
Function
for output frequency monitor "d001" is displayed.
0.00
.
Data
00 Complete display
01 Individual display of functions
02 User setting
03 Data comparison display
04 Basic display
00 Screen when the Enter key was pressed last
01 d001 (Output frequency monitor) (factory default)
02 d002 (Output current monitor)
03 d003 (Rotation direction monitor)
04 d007 (Frequency conversion monitor)
05 F001 (Output frequency setting/monitor)
00 Disabled
01 Enabled
*
from any display on the Digital Operator, refer to
0.00
dk0k0k1
*
or 0.00 .
Description
(factory default)
(factory default)
*
and 0.00 alternately.
3-10
3