Emptying Dust Boxes; To Empty The Dust Box Of Pu-501 - Konica Minolta bizhub 500 User Manual

10
10.4

Emptying Dust Boxes

Even when the punch dust box of the Finisher FS-511 is full, the message is
not displayed. Before using punch mode, perform the following procedure to
check if the punch dust box, if needed. To empty the dust box, see the fol-
lowing pages.
When the punch dust box of the Punch unit PU-501 mounted on the Finisher
FS-510, the following message will be displayed on the screen, and the fin-
ished set will be output without being punched. To empty the dust box, see
page 10-24.
To empty the dust box of FS-511
0 Even when the punch dust box is full, the message is not displayed. Be-
fore using punch mode, perform the following procedure to check if the
punch dust box, if needed.
0 The punch dust box is not disposable. Be sure to return it to its original
position.
1
Slide the finisher to the left.
– Holding the finisher
handle on the top,
slide the finisher to
the left until it stops.
10-22
Supplies & Handling
bizhub 500/420