Printing Page Number (Page #); To Copy Using Page - Konica Minolta bizhub 500 User Manual

Application Functions
8
Touch [OK] to return to the Application Screen.
– Touch [Cancel] on the Date/Time Screen, Print Position Screen, or
Fine-Tune Screen to cancel the setting change.
9
Select additional copy conditions, as desired.
10
Press [Start] on the control panel.
The machine will start scanning the original, then printing when ready
for output.
Note
To release the selected application function, touch [OFF].
To release all the application functions, touch [Reset].
To resume the initial setting for all settings including application function,
press [Reset] on the control panel.
Note
If no other setting is desired, the copy job can be started using the set-
tings currently specified without touching [OK] to return to the Application
Screen or Basic Screen.

5.15.2 Printing Page Number (Page #)

To copy using Page #

0 Specify the start number. Use a minus value, if required.
For example, enter –1 to set the third page as page 1. Available range for
this setting is –99999 ~ 99999.
0 When Chapters is used in combination, the start number for the first page
of each chapter can also be specified. Available range for this setting is
–999 ~ 999.
0 Select one from the five types of page number format.
0 When Cover Mode is used in combination, the Insert Sheet Setting allows
you to select whether or not to print the page number on cover pages.
0 The desired print position can be selected from nine areas. If required,
make fine adjustment of the selected position both in lengthwise and
widthwise directions by entering a value from 1/16 to 1-15/16 in. in 1/16
in. increments.
1
Position the original.
bizhub 500/420
5
5-95