Buell 2002 X1 Handbook page 99

HOME
14. Install actuator rod to rear brake pedal with locknut (met-
ric). Tighten locknut to 7-9 ft-lbs (10-12 Nm).
15. See Figure 2-82. Install right side passenger footrest
mounting bracket with two screws and locknuts. Tighten
screws to 13-16 ft-lbs (18-22 Nm).
16. See Figure 2-82. and Figure 2-83.
center tie bars to frame with original locknuts. Tighten
bolts to 30-33 ft-lbs (41-45 Nm). Install rear tie bar to
mount block with lockwasher. Tighten bolt to 30-33 ft-lbs.
(41-45 Nm).
17. Remove hoist from tail section.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
18. Install fuel tank, fuel tank cover and seat. See
TANK
19. Connect negative battery cable to negative battery termi-
nal.
11 1
WARNING
Check for proper brake lamp operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper brake lamp operation could
result in death or serious injury.
20. Turn ignition key ON, depress rear brake pedal and
check for proper brake light operation.
21. Test ride motorcycle at low speed and check for proper
operation.
2-52
Install front lower and
WARNING
4.37 FUEL
WARNING
2002 Buell X1: Chassis