Buell 2002 X1 Handbook page 408

HOME
Rear
1. See Figure 7-45. Insert bullet connectors through rear
hole in trunk. Attach turn signal (3) using lockwasher (2)
and nut (1).Tighten nut to 96-120 in-lbs (11-14 Nm).
2. Attach bullet connectors on turn signal wires as shown in
Figure 7-44.
3. Use new cable straps to bundle turn signal wires
beneath tail section.
1 1
WARNING WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
2002 Buell X1: Electrical
b0621x7x
BN LT.BE
BK BE
R/Y
BK
O/W
V
R/BK
BK BE
Figure 7-44. Rear Turn Signal Connections
6839
3
1. Nut
2. Lockwasher
3. Turn Signal
4. Cable Strap
Figure 7-45. Rear Turn Signals
Right Turn
Signal
Tail Lamp
Left Turn
Signal
1
2
4
7-35