Turn Signals - Buell 2002 X1 Handbook

HOME

TURN SIGNALS

REMOVAL
Bulbs
Remove screw on back of housing to access turn signal
bulbs.
Front
1. Remove windscreen and headlamp. See
LAMP.
2. See Figure 7-42. Disconnect bullet connectors on turn
signal wires.
3. See Figure 7-43. Remove nut (1) and lockwasher (2)
from mounting bracket (3).
4. Remove turn signals (4) and standoffs (5).
5. Pull bullet connectors (6) and wiring through hole in
mounting bracket (3).
Rear
1. Remove trunk. See 2.37
2. Cut cable straps to access bullet connectors under tail
section.
3. See Figure 7-44. Disconnect bullet connectors on turn
signal wires.
4. See Figure 7-45. Remove nut (1) and lockwasher (2).
5. Remove turn signal (3) from outside of trunk.
INSTALLATION
Front
1. See Figure 7-43. Insert bullet connectors (6) through
hole in mounting bracket (3).
2. Install turn signal (4) and standoffs (5) using lockwasher
(2) and nut (1). Tighten nut to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 7-42.
4. Install and align headlamp. See
1 1
WARNING WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
7-34
7.11 HEAD-
TRUNK.
7.11 HEADLAMP.
b0620x7x
Right Turn
Signal
POSITION LMP
HIGH BEAM
LOW BEAM
LMP GROUND
Headlamp
Left Turn
Signal
Figure 7-42. Front Turn Signal Connections
b0619a7x
4
5
1. Nut (2)
2. Lockwasher (2)
3. Mounting Bracket (2)
4. Turn Signal (2)
5. Turn Signal Standoff (2)
6. Bullet Connectors (2 per signal)
Figure 7-43. Front Turn Signals
7.13
R/BK BN
BE B K
O/W 1 O/W
W 2 W S9
Y 3 Y
BK 4 BK
Headlamp
Connector
S4
S5
LT.BE V
BE BK
1
2
3
6
2002 Buell X1: Electrical