Buell 2002 X1 Handbook page 220

Hide thumbs Also See for 2002 X1:

Table of Contents

CHECK ENGINE LAMP ON CONTINUOUSLY

If the engine stop switch is set to RUN with the engine off,

and the ignition key switch is turned ON, the check engine

lamp should illuminate for four seconds. See

Following the initial period of illumination, the lamp should go

off for four seconds. It may then come back on for an eight

second period (for a stored error) or remain on continuously

(current error).

Diagnostic Notes

The reference numbers below correlate with the circled num-

Figure 4-23.

If the lamp goes off when the black

ECM connector [10] is unplugged, the BK/Y wire is not

shorted to ground.

Figure 4-22.

Figure 4-22. Check Engine Lamp

ECM Connector [11]

ECM Connector [10]

Figure 4-23. Electronic Control Module

2002 Buell X1: Fuel System

Check Engine

Chapters

Table of Contents