Buell 2002 X1 Handbook page 265

HOME
Code 23/32 Test (Part 2 of 2)
2
With the engine off, Scanalyzer (Active Diagnostic
Test Mode) can be used to energize either the front
1
or rear injector once each second for a total of five
seconds.
2002 Buell X1: Fuel System
Continued from Code 23/32 Test (Part 1 of
Check for 12 volts at Terminal 87
of the ignition relay.
Is there 12 volts at Terminal 87?
YES
Ignition relay is OK. Measure resistance
between Terminal 87 of the ignition relay and
Terminal 2 (W/Y for Code 23 or GN/GY for
Code 32) wire at injector connector.
Is resistance less than 0.5 ohm?
YES
With DVOM still
attached, perform 4.8
WIGGLE TEST to locate
intermittents. Repair
as necessary.
7820
SCANALYZER NOTES
2).
Check for multiple codes.
See 4.4 CHECKING FOR
TROUBLE
Find and repair
connection or
open wire.
Clear codes and confirm proper
operation with no check engine
lamp.
With the engine off, Scanalyzer (Active Diagnostic
Test Mode) can be used to turn fuel pump on for
2
periods up to 30 seconds. Power to the pump also
includes power to the fuel injectors and ignition
coil.
NO
CODES.
NO
7825
4-69