Buell 2002 X1 Handbook page 116

HOME
FOOTRESTS
REMOVAL
1. See Figure 2-111. To remove rider footrest.
a. Remove retaining ring (1) and washer (2) from pin
(3).
b. Hold hand over spring (4) and remove pin, spring
and footpeg (5) from mount (6).
2. If necessary, detach passenger footrest (7) by removing
bolt (8) and nut (9) from frame mount.
INSTALLATION
1. If removed, install passenger footrest.
a. See Figure 2-111.
LOCKER 243 (blue) to footrest bolt (8).
b. Secure footrest to frame mount with bolt (8) and nut
(9). Tighten to 10-15 ft-lbs (14-20 Nm).
2. Install rider footrest.
NOTE
If footrest mount (6) was removed, apply LOCTITE THREAD-
LOCKER 271 (red) to bolt, install and tighten bolt to 23-25 ft-
lbs (31-34 Nm).
a. Position spring (4) on mount (6) with thick side of
spring inboard.
b. Install pin (3) through spring (4), mount (6) and foot-
rest (5).
c. Install washer (2) and retaining ring (1) to pin (3).
Make sure retaining ring engages groove in pin.
2002 Buell X1: Chassis
Apply LOCTITE THREAD-
9
b0671a2x
7
8
10-15 ft-lbs
(14-20 Nm)
Blue Loctite
5
1. Retaining Ring
2. Washer
3. Pin
4. Spring
5. Rider Footrest
6. Mount
7. Passenger Footrest
8. Bolt
9. Nut
Figure 2-111. Footrests
2.29
1 2
4
3
6
2-69