Disconnection And Removal - Buell 2002 X1 Handbook

HOME
4. See Table 7-5. Load battery at 50% of CCA rating using
the load tester. Voltage reading after 15 seconds should
be 9.6V or more at 70°F. (21°C).
Table 7-5. Battery Load Test
COLD CRANKING
AMPERAGE (CCA)
SPORT (BUELL)
1 1
WARNING WARNING
Always turn the battery load tester OFF before discon-
necting the tester cables from the battery terminals. Dis-
connecting tester cables with the load tester ON could
cause a spark resulting in a battery explosion which
could result in death or serious injury.
5. Install the battery on the motorcycle. See
INSTALLATION AND CONNECTION.

DISCONNECTION AND REMOVAL

1. Remove seat. See 2.40
1 1
WARNING WARNING
To protect against accidental start-up of vehicle, discon-
nect the negative battery cable before proceeding. Inade-
quate safety precautions could result in death or serious
injury.
1 1
WARNING WARNING
Always disconnect the negative battery cable first. If the
positive battery cable should contact ground with the
negative cable installed, the resulting sparks may cause
a battery explosion which could result in death or seri-
ous injury.
2. Unthread bolt and remove battery negative cable (black)
from battery negative (-) terminal.
3. Unthread bolt and remove battery positive cable (red)
from battery positive (+) terminal.
4. Remove battery strap locknut (metric). Unhook battery
strap from frame near negative terminal.
5. Cut cable strap holding oxygen sensor connector to bat-
tery.
6. Remove battery from right side.
2002 Buell X1: Electrical
100% 50%
270 135
BATTERY
SEAT.
Figure 7-33. Load Test
CLEANING AND INSPECTION
1. Battery top must be clean and dry. Dirt and electrolyte on
top of the battery can cause battery to self-discharge.
Clean battery top with a solution of baking soda (sodium
bicarbonate) and water (5 teaspoons baking soda per
quart or liter of water). When the solution stops bubbling,
rinse off the battery with clean water.
2. Clean cable connectors and battery terminals using a
wire brush or sandpaper. Remove any oxidation.
3. Inspect the battery screws, clamps and cables for break-
age, loose connections and corrosion. Clean clamps.
4. Check the battery posts for melting or damage caused
by overtightening.
5. Inspect the battery for discoloration, raised top or a
warped or distorted case, which might indicate that the
battery has been frozen, overheated or overcharged.
6. Inspect the battery case for cracks or leaks.
Load
Tester
Induction
Pickup
f1731x8x
7-27