Buell 2002 X1 Handbook page 415

HOME
INSTALLATION
1. If replacing speedometer wiring:
a. See Figure 7-59. Attach wires at plug connector.
b. Feed wiring through to dash panel and secure with
ties on electrical cabling.
c. Install fuel tank. See
2. Install odometer reset.
d. See Figure 7-57. Install odometer reset button (3)
from back side of dash panel.
e. See Figure 7-56. Secure odometer reset button (3)
on front of dash panel with plastic grommet (2).
3. Install rubber mounting gasket if removed.
a. Apply 2 drops of adhesive (Permabond 105) at each
end of notches in gasket.
b. Apply 1 drop of adhesive (Permabond 105) at top of
gasket and bottom of gasket.
c. Position mounting gasket in dash panel.
4. Install speedometer in dash panel.
a. Feed wires through opening in speedometer cover.
b. Slide speedometer into rubber mounting gasket.
c. See Figure 7-58. Insert lamp (5).
d. Attach wires to speedometer as shown.
5. See Figure 7-57. Install speedometer cover (6).
a. Place speedometer cover over speedometer. Align
posts on back of speedometer with holes in cover.
Drain hole must be at the bottom of cover.
b. Apply LOCTITE THREADLOCKER 243 (blue) to
both nuts (metric) (4).
c. Fasten cover (6) to speedometer using two nuts
(metric) (4) and lockwashers (5).
6. See Figure 7-56. Position dash panel on instrument sup-
port clamp.
a. Attach dash panel using two screws (1) to hold
panel to clamp.
b. Tighten screws to 4-5 ft-lbs (5-7 Nm).
c. Attach windscreen to mounting brackets using four
screws and washers.
7-42
4.37 FUEL TANK.
6940
3
2
1
1. Silver Blue/White
2. White/Green
3. Red
4. Orange/White
5. Lamp
6. Black
Figure 7-58. Speedometer Wiring
6805
Figure 7-59. Speedometer Wiring Connector
Locations (Approximate)
5
4
6
2002 Buell X1: Electrical