Rear Fender - Buell 2002 X1 Handbook

HOME

REAR FENDER

REMOVAL
1. See Figure 2-115. Loosen two bolts (1) securing footrest
mounts (2) on both sides.
2. See Figure 2-116. Remove two screws (1) and washers
(2) from right side wellnuts (4).
3. Remove screw (5) and washer (6) from front wellnut (7).
4. Remove screw (8) washer (9) and clamp from left side.
5. Pull fender (3) over rear tire.
INSTALLATION
1. See Figure 2-115. Position fender (3) over tire, making
sure that the brake line (4) is on the inside of the fender
as shown.
2. Have someone sit on the vehicle to compress the motor-
cycle's suspension.
3. See Figure 2-116. Install hardware in reverse order.
Apply LOCTITE THREADLOCKER 243 (blue) to all
screws.
4. Attach footrest mounts on both sides. Tighten bolts to 13-
16 ft-lbs (18-22 Nm).
2-72
6820
2
1
1
1. Bolts (2)
2. Passenger Footrest Mount
3. Fender
4. Brake Line
Figure 2-115. Rear Fender With Brake Line (Left Side)
b0608x2x
3
2
1
1. Screw (2)
2. Washer (2)
3. Fender
4. Wellnut (2)
5. Screw
6. Washer
7. Wellnut
8. Screw
9. Washer
Figure 2-116. Rear Fender
2.32
4
3
8
9
4
6
7
5
2002 Buell X1: Chassis