Buell 2002 X1 Handbook page 425

Hide thumbs Also See for 2002 X1:

Table of Contents

TROUBLESHOOTING

If the horn does not sound or fails to function satisfacto-

rily, check for the following conditions:

Discharged battery.

Loose, frayed or damaged wiring leading to horn ter-

If battery has a satisfactory charge and wiring appears to

be in good condition, test horn grounds and switch using

Figure 7-69.

ground wires from terminal clips.

Connect voltmeter positive (+) lead to Y/BK wire.

Connect voltmeter negative (–) lead to ground.

Turn ignition key switch to IGN.

Figure 7-70.

Depress horn switch and observe volt-

meter reading.

If battery voltage is present, horn or horn grounding

is faulty. If horn is faulty, replace unit as an assem-

bly. The horn is not repairable.

If battery voltage is not present, either horn switch or

wiring to horn is faulty. If horn switch is faulty,

replace left handlebar switch. See

Remove Y/BK power and BK

7.15 HANDLE-

Figure 7-70. Horn Switch

2002 Buell X1: Electrical

Chapters

Table of Contents