Table of Contents
Advertisement
HOME
INSTALLATION
1.
Place wheel centrally in the swingarm with the brake
rotor in the caliper. Slide wheel far enough forward to slip
belt over sprocket and then slide wheel back.
2.
Install rear axle.
a.
Apply LOCTITE ANTI-SEIZE LUBRICANT to axle.
b.
See
Figure 2-11.
Insert axle (1) through washer (2)
so that rounded side of washer will face swingarm.
Continue through axle carrier (3), left side of swing-
arm (4), rear brake caliper mount (5) and wheel
assembly.
c.
See
Figure 2-12.
Place spacer (7) between wheel
hub and right side of swingarm (6). Slide axle (1)
through spacer, swingarm and axle carrier (5).
d.
Place washer (4) on axle with rounded side facing
swingarm. Install lockwasher (3) and axle nut (2)
(metric). Do not fully tighten rear axle nut at this
time.
3.
Attach rear brake caliper to caliper mount. See
REAR BRAKE CALIPER.
4.
Check for proper belt tension and wheel alignment. See
1.11 DRIVE BELT
DEFLECTION.
5.
Tighten rear axle nut (14) (metric) to 66-73 ft-lbs (90-
99 Nm).
2002 Buell X1: Chassis
6974
3
1
1.
Axle
2.
Washer
3.
Axle Carrier
4.
Swingarm
5.
Rear Brake Caliper Mount
2.14
Figure 2-11. Axle, Left Side
7042
7
6
1.
Axle
2.
Axle Nut (metric)
3.
Lockwasher
4.
Washer
5.
Axle Carrier
6.
Right Side of Swingarm
7.
Spacer
Figure 2-12. Axle, Right Side
5
4
2
4
1
2
5
3
2-13
Advertisement
Chapters
Table of Contents
Troubleshooting
