Turn Signals - Buell P3 2003 Service Manual

HOME

TURN SIGNALS

REMOVAL
NOTES
Remove screw on back of turn signal to detach lens and
install new turn signal bulbs.
Front bulbs are identical to rear bulbs.
Front
1. Remove four screws, washers and windscreen. See
WINDSCREEN.
2. See Figure 7-66. Disconnect two bullet connectors on
turn signal wires.
3. See Figure 7-67. Remove nut and lockwasher
4. Remove turn signal from headlamp bracket.
5. Repeat steps 2-4 for other turn signal.
Rear
1. Cut cable strap that secures bullet connectors under tail
section.
2. See Figure 7-69. Disconnect two bullet connectors on
turn signal wires.
3. See Figure 7-68. Remove nut and lockwasher.
4. Remove turn signal from tail lamp bracket.
5. Repeat steps 2-4 for other turn signal.
INSTALLATION
Front
1. See Figure 7-67. Install turn signal with lockwasher and
nut. Tighten nut to 25-28 in-lbs (2.8-3.2 Nm).
NOTE
Install turn signal with lens drain hole facing downward.
2. Attach two bullet connectors on turn signal wires as
shown in Figure 7-66.
3. Install four screws, washers and windscreen. See
WINDSCREEN.
11 1
WARNING
Check for proper turn signal operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper turn signal operation could
result in death or serious injury.
4. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Activate left turn signals using switch on left handle-
bar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left han-
dlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
7-52 2003 Buell P3: Electrical
WARNING
a0255x7x
Right front directional lamp
Headlamp
2.26
Left front directional lamp
Figure 7-66. Front Turn Signal Connections
1. Front turn signal assembly
2. Bullet connectors (2)
3. Lockwasher
4. Nut
a0485x7x
Figure 7-67. Front Turn Signals
2.26
a0257x7x
1. Outer lens
2. Inner lens
3. Bulb
4. Bullet connectors (2)
5. Nut
6. Lockwasher & screw
Figure 7-68. Rear Turn Signals
7.19
R/BK BN
BE B K
1
HIGH BEAM W 2 W
S9
LOW BEAM Y 3 Y
LMP GROUND
BK 4 BK
[38]
S4
S5
LT.BE V
BK
B E
4
3
2
1