Disconnection And Removal; Battery Charging; Safety Precautions - Buell 2005 P3 Service Manual

HOME

DISCONNECTION AND REMOVAL

1. Remove seat. See 2.28
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect battery cables
(negative (-) cable first) before proceeding. (00307a)
11 1
WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Unthread bolt and remove battery negative cable (black)
from battery negative (-) terminal.
3. Unthread bolt and remove battery positive cable (red)
from battery positive (+) terminal.
4. Remove battery from motorcycle.
CLEANING AND INSPECTION
1. Battery top must be clean and dry. Dirt and electrolyte on
top of the battery can cause battery to self-discharge.
Clean battery top with a solution of baking soda (sodium
bicarbonate) and water (5 teaspoons baking soda per
quart or liter of water). When the solution stops bubbling,
rinse off the battery with clean water.
2. Clean cable connectors and battery terminals using a
wire brush or sandpaper. Remove any oxidation.
3. Inspect the battery screws, clamps and cables for break-
age, loose connections and corrosion. Clean clamps.
4. Check the battery posts for melting or damage caused
by overtightening.
5. Inspect the battery for discoloration, raised top or a
warped or distorted case, which might indicate that the
battery has been frozen, overheated or overcharged.
6. Inspect the battery case for cracks or leaks.

BATTERY CHARGING

Safety Precautions

Never charge a battery without first reviewing the instructions
for the charger being used. In addition to the manufacturer's
instructions, follow these general safety precautions:
Always wear proper eye, face and hand protection.
Always charge batteries in a well-ventilated area.
Turn the charger "OFF" before connecting the leads
to the battery to avoid dangerous sparks.
Never try to charge a visibly damaged or frozen bat-
tery.
7-46 2005 Buell P3: Electrical
SEAT.
WARNING
WARNING
Connect the charger leads to the battery; red posi-
tive (+) lead to the positive (+) terminal and black
negative (–) lead to the negative (–) terminal. If the
battery is still in the vehicle, connect the negative
lead to the chassis ground. Be sure that the ignition
and all electrical accessories are turned off.
Make sure that the charger leads to the battery are
not broken, frayed or loose.
If the battery becomes hot, or if violent gassing or
spewing of electrolyte occurs, reduce the charging
rate or turn off the charger temporarily.
Always turn the charger "OFF" before removing
charger leads from the battery to avoid dangerous
sparks.
Charging Battery
Charge the battery if any of the following conditions exist:
Vehicle lights appear dim.
Electric starter sounds weak.
Battery has not been used for an extended period of
time.
11 1
WARNING
Explosive hydrogen gas, which escapes during charg-
ing, could cause death or serious injury. Charge battery
in a well-ventilated area. Keep open flames, electrical
sparks and smoking materials away from battery at all
times. KEEP BATTERIES AWAY FROM CHILDREN.
(00065a)
CAUTION
If the battery releases an excessive amount of gas during
charging, decrease the charging rate. If the battery gets
hotter than 110˚F. (43˚C) during charging, discontinue
charging and allow the battery to cool. Overheating may
result in plate distortion, internal shorting, dry out or
other damage.
1. Perform a voltmeter test to determine the state of charge.
See BATTERY TESTING, VOLTMETER TEST.
11 1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
CAUTION
Remove battery from motorcycle before charging. Elec-
trolyte leakage will damage motorcycle parts. (00213a)
2. Install the battery on the motorcycle. See
INSTALLATION AND CONNECTION.
WARNING
WARNING
BATTERY