Recording And Playing The Dps16'S Snapshot On A Midi Sequencer - Akai DPS16 Operator's Manual

Recording and playing the DPS16's snapshot on a MIDI sequencer

The DPS16 can transmit and receive a mix snapshot (mix parameter settings) as a series of MIDI Control Change
messages. If you record this snapshot to a MIDI sequencer, you can play back the same mix settings each time you
play the MIDI sequencer.
Follow the steps below to record and play a mix snapshot on a MIDI sequencer.
1. Use MIDI cables to connect the MIDI IN/OUT connectors of the DPS16 to the MIDI OUT/IN
connectors of a MIDI sequencer.
DPS16
2. Press the [F3] (
MISC.
screen is set to "
OUT
If it is set to " THRU
3. Play the DPS16 and create a mix to record as a snapshot.
4. Press the [F3] (
GLOBAL
The following screen appears.
5. Move the cursor to the
channel (1–16) to transmit the Control Change messages.
MIDI IN
MIDI OUT
) key in Setup mode and make sure that the
".
", move the cursor to the field and set to "
) key in Mixer mode.
Tx mixer change
Control Change
Control Change
MIDI IN
JOG SHUTTLE
MIDI out/thru
OUT ".
field and turn the [JOG] wheel to select a DPS16's MIDI
Chapter 12: MIDI Applications
MIDI OUT
MIDI sequencer
field on the
139