Eq On/Off; Eq High F/Eq Mid F/Eq Low F (Eq Frequency) - Akai DPS16 Operator's Manual

Chapter 6: Mixer Function
NOTE :
setting. The number of effects you can use simultaneously is also affected in the same way. If the sampling
rate is 32kHz, 44.1kHz, or 48kHz, you can use up to four AUX SENDs (and effects). If the sampling rate is
96kHz, you can use up to two AUX SENDS (and effects). For more information on the Project's sampling
rate setting, see page 24 and 106.

EQ ON/OFF

You can turn the channel EQs on and off.
Range: ON/OFF
NOTE :
neously. If the sampling frequency is set to 32kHz, 44.1kHz, or 48kHz, you can use the EQs on up to 16
channels. If the frequency is set to 96kHz, you can use the EQs on up to 6 channels. For more information
on the Project sampling frequency, see page 24 and 106.
TIPS :
• You can also use the
(TRACK MIX channels) to turn the EQs on and off.
• If you wish to apply EQ to a recording signal, use the EQ on the INPUT MIX channel that inputs the
signal.

EQ HIGH F/EQ MID F/EQ LOW F (EQ frequency)

You can set the center frequency for each EQ band.
Range: HIGH: 500Hz–18kHz, MID: 200Hz–8kHz, LOW: 40Hz–1.5kHz
TIP :
for more information.
68
(Mixer Mode)
The number of AUX SENDs you can use simultaneously varies depending on the sampling rate
The Projects' sampling frequency setting affects the number of the EQs you can use simulta-
[INPUT SELECT]
You can also use the QLMC knobs on the top panel to control the center frequencies. See page 19
keys (INPUT MIX channels) or the keys
[TRACK SELECT]