When the QLMC mode is set to MIXER:
Pressing the
key repeatedly toggles the following two options:
[F6]
•
................ Enables you to adjust the center frequency (
EQ
band
EQ
•
SEND
........... Enables you to adjust the
When the QLMC mode is set to EFFECT:
Pressing the
key repeatedly toggles the four options in the following order:
[F6]
•
FX1
.............. Parameters of the effect selected for FX1
•
FX2
.............. Parameters of the effect selected for FX2
•
FX3
.............. Parameters of the effect selected for FX3
•
FX4
.............. Parameters of the effect selected for FX4
Follow the steps below to operate the QLMC section.
1. Press the [F5] key to select
2. Press the [F6] key to select a mix parameter you wish to control.
If you have selected "
Step 1, you can select
3. If you have selected "
[MASTER] key to select the target channel.
The first line of the QLMC section on the screen indicates the selected channel number.
4. Operate the Q-Link knobs ([C1] – [C6] knobs).
The corresponding parameter's value changes.
See page 75 for more information on how to control mix parameters using the QLMC section, and page 147
for more information on how to control effect parameters using the QLMC section.
(High, Mid, Low).
Send
(AUX send)
or
MIXER
EFFECT
MIXER
" in Step 1, you can select
FX1
–
FX4
.
" in Step 1, use the [INPUT SELECT] keys, [TRACK SELECT] keys, and
MIXER
Chapter 1: Overview of the DPS16
) and the boost/cut amount (
Freq
1
-
4
,
Pan
, and
Level
as the QLMC mode.
EQ
or
SEND
here. If you have selected "
) of the 3-
Level
.
EFFECT
" in
19