Canceling The Patch; Routing A Recording Source To Multiple Tracks - Akai DPS16 Operator's Manual

NOTE : When you select the input signal as the recording source, make sure that the input signal is
routed to the Source section on the Quick Patch screen (that is, a thick line is descending). Even if you
select the input signal (an ascending thick line) sent directly to the master section, it will not be sent to
any tracks. Use the [INPUT SELECT]

Canceling the patch

To cancel the patch, press and hold down the
disconnect), and press the
For example, while the Quick Patch screen shown above is displayed, pressing and holding down the
1 key and pressing the
SELECT]

Routing a recording source to multiple tracks

To route a recording source to multiple tracks, while pressing and holding down the
press the [RECORD SELECT]
For example, while the Quick Patch screen shown above is displayed, pressing and holding down the
1 key and pressing the
SELECT]
key to change the direction of the thick patch line.
[TRACK SELECT]
key of the corresponding track.
[RECORD SELECT]
[RECORD SELECT]
keys of the desired tracks in order.
[RECORD SELECT]
Chapter 5: Assigning Input Signals and Tracks
key of the recording source (that you wish to
1 key will change the setting as follows.
1–4 keys will change the setting as follows.
[TRACK
key,
[TRACK SELECT]
[TRACK
55