Akai DPS16 Operator's Manual page 127

4. Move the cursor to the
• IN-OUT ........................ Writes a region between the IN and OUT points of the track selected in step 3.
• ALL ............................... Writes the entire audio data of the track selected in step 3.
NOTE : If the Region field is set to "
will be written onto the disc, even if the track contains silent parts. This length (duration) does not necessarily
match the overall length of the Project.
5. Move the cursor to the
• MAX ............................... Writes data at the fastest speed of the connected drive available within the range of x1
• SLOW (x1) .................. Writes data at normal speed. Writing takes about the same time as the recording time
• FAST (x2) .................. Writes data at 2x speed. Writing takes about half of the recording time indicated in the
• ............................ Writes data at 3x speed. Writing takes about 1/3 of the recording time indicated in the
(x3)
• (x4) ............................ Writes data at 4x speed. Writing takes about 1/4 of the recording time indicated in the
6. Set the
Test write
TIP : Test write is a process in which a weak laser is projected onto the disc surface to check whether any
malfunctions will occur during writing data transfer. If you have not written data to discs at all or have only
done so a few times, perform the test write process.
7. Press the [F6] (
WRITE
The DPS16 displays the screen for confirming execution of writing.
8. Press the [F5] (
DO IT
• If you have set the Test write field to "ON" in step 6, the test write process starts. When the test write process
finishes, actual writing starts.
• If you have set the Test write field to "OFF", press the
• Press the [F1] ( CANCEL
• When writing is completed, the DPS16 returns to the Project screen.
TIP : You can continue the writing operation to record other tracks or other Projects to the same CD-R/CD-
RW disc by repeating the procedure from step 1 as long as you do not perform the Finish process (explained
on page 117.)
field (3) and select the track region (
Region
ALL ", the entire length of the selected track from beginning to end
field (4) and select the writing speed.
Write speed
to x4. Writing time varies depending on the speed selected.
indicated in the
Write length
Write length field.
Write length field.
Write length field.
field (7) to ON to perform test write.
) key.
) key to execute writing.
) key to cancel writing.
Chapter 10: Project Management (Project Mode)
IN-OUT
field (6).
[F6] ( WRITE ) key to start writing.
/ ) to write.
ALL
115