Table of Contents
Advertisement
Default Setting
[EMPTY MODE]: STOP
Displaying the Amount of Media Remaining
You can display how much of the media in use is left. First, you set the amount of media remaining, the amount
remaining is displayed at the top menu until it reaches zero.
Procedure
Press
.
MENU
SHEET REMAIN
SHEET REMAIN
SET LENGTH
SET LENGTH
0.0 m
25.0 m
W 1200mm
L 25. 0m
This display is updated.
SETUP SHEET
ROLL
L 25. 0m
Description
If you cancel the setup such as by removing the media or raising the loading lever, the amount remaining at
that time flashes on the screen. Because the amount of media remaining is not updated automatically when
you change the media, redo the setting whenever you change the media.
Note, however, that when sheet media is loaded (that is, when [SETUP SHEET] is set to "PIECE"), the setting for
the amount of remaining media is made automatically.
You can also make the setting display this menu automatically whenever you change the media. See the
next section, "Making Sure to Verify the Setting for the Amount Remaining Every Time the Media Is Changed"
Note: The remaining amount that is displayed is only an estimate, and its accuracy is not assured.
Press
twice to display the left figure.
Press
, and then
Press
.
Press
remaining.
Press
to enable the setting.
Press
screen.
If setup has not been performed,
the set value flashes.
Output Operation Management
.
to set the current amount of media
in this order to go back to the original
5
147
Advertisement
Table of Contents
