Table of Contents
Advertisement
An Error Message Appears
This describes the error messages that may appear on the machine's display, and how to take
action to remedy the problem. If the action described here does not correct the problem, or if an
error message not described here appears, contact your authorized Roland DG Corp. dealer .
[ALIGN POINT POSITION INVALID]
An attempt was made to set an align point at a location where the setting cannot be made.
No align point can be set when the angle of the base point and the align point is too large. Reload the media
correctly, so that the angle is minimized, then set the base point and the align point again to match the crop
marks.
P. 129, "Performing Printing and Cutting Separately"
[OPTION-DRYER IS NOT CONNECTED]
When the drying-heater unit is not connected to the printer, [OPTION DRYER] is set to "ENABLE." Switch the
sub power and main power off, and then connect the drying-heater unit to the printer.
[HEATING TIMEOUT CONTINUE?]
The print heater or dryer did not reach the preset temperature.
This occurs because the temperature of the location where the machine is installed is too low. We recommend
raising the temperature. To continue waiting for the temperature to rise, press
immediately, press
[CARRIAGES ARE SEPARATED]
The cutting carriage and the print-head carriage were improperly disconnected.
A problem such as a media jam occurred, impeding correct operation. Operation cannot be continued. Switch
the sub power off, then back on.
[CROPMARK ERROR NOT FOUND]
Automatic detection of crop marks could not be accomplished.
Load the media at the correct position and perform detection of crop marks again. Depending on the media,
it may not be possible to detect crop marks automatically. If repeating automatic crop-mark detection results
in an error again, then perform manual crop-mark detection.
P. 129, "Performing Printing and Cutting Separately"
[CAN'T PRINT CROP CONTINUE?]
The size of the data including the crop marks is larger than the printing or cutting area of
the loaded media.
To continue performing output without correcting this, press
beyond the printing or cutting area and the crop marks are not printed. To stop output, stop sending data from
the computer, then raise the loading lever. Make the printing or cutting area wider, such as by replacing the
media with a larger piece of media or by changing the positions of the pinch rollers, then send the data again.
.
. To start printing
. At this time, the portion extending
6
175
Advertisement
Table of Contents
