Table of Contents
Advertisement
Important Note on Cutting
When you're performing cutting only, never use the media clamps.
When you're performing cutting only, remove the media clamps or move to the locations where they don't
clamp the media.
When using the roll media and only performing cutting, let the media hang down to the
rear of the machine. (or set the [PREFEED] menu to "ENABLE.")
This prevents a motor error or fall of the roll because the media is pulled with excessive force.
For the [PREFEED] menu, refer to P. 120, "Preventing Pulling of the Media with Undue Force When Performing
Cutting Only"
Turn the media by hand
to pull out the necessary
length from the roll. If the
media is hanged down from
the rear of the machine, you
can leave the [PREFEED]
function "DISABLE."
When you're performing printing followed immediately by cutting (Print and Cut), then
before you start cutting, allow the ink to dry sufficiently.
Use your software RIP to make the setting for the drying time. For information on how to make the setting,
refer to the documentation for the software RIP you're using. The drying time varies according to the media.
Outputting
2
65
Advertisement
Table of Contents
