Default Setting - Roland XR-640 User Manual

Examples of Preset Temperatures
Media
Type: Scrim banner (PVC)
Thickness: 300 to 400 μm (12 to 16 mil)
Type: Marking film (PVC, with adhesive)
Thickness: 60 to 100 μm (2.5 to 4 mil, not including
backing paper)
 These are only rough estimates. Make adjustments to match the media you're using.
 Using the media heating system does not necessarily make it possible to apply ink to every kind of media.
Be sure to test in advance.
 Results may vary greatly depending on the print mode and other factors. Make settings suited to the media.
 When suggested settings for temperature, print mode, and other values are given, use the suggested settings.
Description
By default setting, simply switching on the power does not make the media heating system warm up to the
preset temperature. The temperature rises until preset temperature when the media is loaded correctly and
lights up. You can also make this setting on the software RIP. When you have made the setting on
the software RIP, the software RIP's setting is used.
 Depending on the usage environment, the temperature of the print heater or dryer may become higher
than the preset temperature, but this does not represent a problem.

Default Setting

[PRE]: 40°C (104°F)
[PRINT]: 40°C (94°F)
[DRY]: 50°C (122°F)
Fully Utilize the Media Heating System
Temperature
Preheater: 40°C (104°F)
Print heater: 40°C (104°F)
Dryer: 50°C (122°F)
Preheater: 40°C (104°F)
Print heater: 40°C (104°F)
Dryer: 50°C (122°F)
4
107