Table of Contents
Advertisement
Using Transparent Media
Procedure
Press
.
MENU
SUB MENU
EDGE DETECTION
ENABLE
DISABLE
SETUP SHEET
ROLL
Description
This setting enables or disables detection of the leading and trailing edges of the media. It is normally set to
"ENABLE." When transparent media is loaded, set it to "DISABLE."
When "DISABLE" is selected, "ROLL," "TU," and "TU2" are available in setting the media. At this time, set the
margin from the leading edge of the media to the print start position to 75 mm or more.
When [EDGE DETECTION] is set to "DISABLE," printing operation does not stop when the media runs out. If
media runs out while printing is in progress, immediately press
chance that the platen or the like may become soiled by ink or that ink may get inside and damage the machine.
Default Setting
[EDGE DETECTION]: ENABLE
Printing Hard-to-dry Media
Procedure
Press
.
MENU
SUB MENU
SUB MENU
SCAN INTERVAL
SCAN INTERVAL
OFF
1. 0sec
Press
Accommodating to the Types and Condition of Media
Press
several times to display the screen shown
on the left.
Press
twice.
Press
Press
to enable the setting.
The settings are changed and the screen shown in the figure appears.
Press
several times to display the screen shown
on the left.
Press
, and then
Press
.
Press
Larger values produce progressively slower movement of the media,
enabling you to extend the drying time accordingly.
Press
to enable the setting.
in this order to go back to the original screen.
to select "DISABLE."
to quit printing. Otherwise, there is a
.
to select a value.
4
115
Advertisement
Table of Contents
