Table of Contents
Advertisement
Fully Utilizing the Correction Function
Correcting for Misalignment in Bidirectional Printing More Precisely
When further correction is required, such as when adjustment made using [SIMPLE SETTING] does not enhance
printing, use [DETAIL SETTING] to make corrections.
For information on operations, refer to P. 49, "Performing the Initial Adjustment (Correcting for Misalignment
in Bidirectional Printing More Precisely)"
Alleviating Horizontal Bands and the Like (feed correction function)
Procedure
When the roll media is used, check that no sagging is found on the media.
Press
MENU
CALIBRATION
CALIBRATION
TEST PRINT
4
SETTING
0.00%
To decide a Correction Value
Select the value to make the upper/lower rectangular gap and overlap smallest.
Press
112
.
Press
on the left.
Press
Press
A test pattern is printed.
When printing is completed, press
this order.
Press
-0.40%
Press
Current correction value
Gap present
in this order to go back to the original screen.
several times to display the screen shown
.
.
to select a correction value.
to enable the setting.
Gap and overlap are smallest.
in
Overlap
Advertisement
Table of Contents
