Accommodating To The Types And Condition Of Media; Adjusting Head Height To Match Media Thickness - Roland XR-640 User Manual

Accommodating to the Types and Condition of Media

Adjusting Head Height to Match Media Thickness

Procedure

Press

MENU
HEAD HEIGHT

HEAD HEIGHT
LOW

4

MENU
HEAD HEIGHT

Press
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When you are using such media, adjust the head height to "HIGH."
Printing quality when the head height is set to "HIGH" may be coarser or otherwise lower than when set to
"LOW. " If this happens, refer to the pages indicated below.
P. 49, "Performing the Initial Adjustment (Correcting for Misalignment in Bidirectional Printing More Precisely)"

 P. 111, "Correcting for Misalignment in Bidirectional Printing"
P. 118, "Preventing Soiling of the Media and Dot Drop-out"

114
.
Press
on the left.
Press
When the left figure is displayed, open the front cover.
LOW
High
Low
Height-adjustment lever
Move firmly, until it stops.
Close the front cover.
The print-head carriage moves to the original position, and then the
screen shown in the figure appears.
in this order to go back to the original screen.
several times to display the screen shown
.
Move the height-adjustment lever to adjust
the head height.
Moving the lever to "HIGH" makes a warning beep
sound twice. Moving it to "LOW" makes the warning
beep sound once.