The Media Take-Up System Doesn't Run - Roland XR-640 User Manual

Is a message displayed on the screen?
 P. 173, "A Message Appears"
 P. 175, "An Error Message Appears"
Is the cable connected?
Connect the cable securely.
 "Setup Guide"
Is the network routing appropriate?
Try connecting the computer and the machine to the same hub, or connecting them directly using a crossover
cable. If this makes it possible to perform output, it means the problem is in the network itself.
Are the network settings correct?
If the cable connections are secure and no problem is found in the network itself, make sure that the IP ad-
dress and other such settings are appropriate. The settings on both the machine and the computer must be
appropriate. Redo the settings, checking to ensure that the IP address doesn't conflict with the IP address for
another device on the network, that the port setting for the software RIP specifies the IP address set on the
machine, that the settings have no typing errors, and for other such problems.
 "Setup Guide"
 P. 151, "Viewing Information about the System of This Machine"
Did the software RIP end abnormally?
Make sure the software RIP is running correctly, then switch the sub power switch off and back on.
 "Roland VersaWorks Quick Start Guide"

The Media Take-up System Doesn't Run

Is the cable connected?
Connect the cable for the take-up unit to the machine. To perform take-up automatically during printing, also
make the setting for the AUTO switch.
 "Setup Guide"
 P. 138, "How to Take Up Media"
Printer Does Not Start Up!
161
6