Accommodating To The Types And Condition Of Media; Adjusting Head Height To Match Media Thickness - Roland VersaArt RA-640 User Manual

Accommodating to the Types and Condition of Media

Adjusting Head Height to Match Media Thickness

Procedure

Press

MENU
HEAD HEIGHT

HEAD HEIGHT
HIGH

H e i g h t - a d j u s t m e n t l e v e r
Move firmly, until it stops.
4

MENU
HEAD HEIGHT

W1200mm
SETUP SHEET
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print head. When you are using such media, adjust the head height to "HIGH."
Printing quality when the head height is set to "HIGH" may be coarser or otherwise lower than when set to
"LOW. " If this happens, refer to the pages indicated below
 P. 91, "Correcting for Misalignment in Bidirectional Printing," p. 41, "Performing the Initial Adjustment (Correcting for
Misalignment in Bidirectional Printing More Precisely)," p.100, "Preventing Soiling of the Media and Dot Drop-out"
94
.
Press
Press
When the left figure is displayed, open the front cover.
LOW
High
Low
Close the front cover.
The print-head carriage moves to the original position, and then the
screen shown in the figure appears.
Press
several times to display the left figure.
.
Move the height-adjustment lever to adjust
the head height.
Moving the lever to "HIGH" makes a warning beep
sound twice. Moving it to "LOW" makes the warning
beep sound once.
to go back to the original screen.