Iwatsu Omega-Phone 924 Technical Manual page 147

Chapter 6
Related Features
N/A
Conditions
1. This is not a programmable parameter
Relay Control
Feature 61
(x) = Relay 1 - 4
There are 4 relays on the Option Module which can be programmed to close when the
code Feature 61 plus the relay 1-4 is dialed. For example, this closure can be used to
open electronic door latches.
Related Features
Conditions
1. The option module must be installed.
2. A programmable key may be programmed to activate a specific relay. When the
relay is activated, the LED on the key will be lit solid.
3. Each Relay can be programmed as a Relay or a Sensor, but not both.
Save Dialed Number (SDN)
Feature 51
Saved Number Redial (SDN) is used to retain a telephone number, which was just
dialed, to be used later. Once stored the number can be recalled by dialing the SDN
feature code, regardless of what feature operations or numbers have been dialed at that
extension since the number was saved. Only one number can be stored at a time.
Related Features
Conditions
1. Saved Dial Number can store a maximum of 16 digits.
2. If all CO Lines are busy when the redial is attempted, the display will show ALL
CO LINES BUSY.
3. The Save Dialed Number feature code may be stored on any Programmable Fea-
ture Key for one-touch storing and dialing operation.
(X)
Programming
Opt Relay Function 4-28
Programming
Telephone Operations
Programming
N/A
143