Chrysler 1998 Voyager Service Manual page 500

8M - 4 RESTRAINT SYSTEM
REMOVAL AND INSTALLATION (Continued)
(2) Remove forward lower console from instrument
panel, refer to Group 8E, Instrument Panel and Sys-
tems for proper procedures.
(3) Remove screw holding lower heat duct to
instrument panel support (Fig. 3).
Fig. 3 Heat Duct
(4) Remove heat duct from instrument panel.
(5) Remove two bolts holding top of right support
to instrument panel (Fig. 4).
Fig. 4 Instrument Panel Supports
(6) Remove two bolts holding bottom of right sup-
port to floor pan.
(7) Separate right instrument panel support from
vehicle.
(8) Disconnect two wire connectors from ACM (Fig.
5).
(9) Remove four bolts holding the ACM bracket
assembly to floor (Fig. 6).
(10) Remove the ACM from vehicle.
Fig. 5 ACM Connectors
Fig. 6 ACM Bracket Assembly
INSTALLATION
WARNING: DO NOT REMOVE THE BOLTS HOLD-
ING THE ACM TO THE ACM BRACKET. THESE
BOLTS ARE SAFETY TORQUED AT THE MANUFAC-
TURING FACILITY AND SHOULD NOT BE REMOVED
FOR ANY REASON. THE NEW ACM WILL COME
WITH A NEW BRACKET INSTALLED.
CAUTION: USE CORRECT
INSTALLING THE ACM
For installation, reverse the above procedures.
Attach the ACM bracket assembly to vehicle with the
proper screws and tighten to 805 to 11.9 N·m (75 to
105 in. lbs.) torque. Do not connect battery negative
cable. Refer to Diagnosis and Testing for Airbag Sys-
tem Test procedures.
NS
SCREWS WHEN