Chrysler 1998 Voyager Service Manual page 149

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 164 Locking Out Automatic Adjuster
Fig. 165 Right Rear Cable Connection To
Intermediate Cable
Fig. 166 Right Park Brake Cable Removal From
Body Bracket
(8) Disconnect park brake cable from park brake
actuator lever.
(9) Remove the park brake cable housing retainer
from the brake support plate using a 14mm wrench
to compress the retaining fingers (Fig. 167).
Fig. 167 Removing Park Brake Cable From Brake
Support Plate
INSTALL
(1) Install the park brake cable in the brake sup-
port plate. Insert cable housing retainer into brake
support plate making certain that cable housing
retainer fingers lock the housing and retainer firmly
into place.
(2) Attach the park brake cable onto the park
brake actuator lever.
(3) Install the brake shoes on the rear brake sup-
port plate. Refer to Rear Brake Shoes in the Removal
And Installation Section of this service manual for
the required procedure.
(4) Insert cable housing retainer into body bracket
making certain that cable housing retainer fingers
lock the housing firmly into place.
(5) Connect the right rear park brake cable to the
connector on the intermediate park brake cable (Fig.
165).
(6) Install the brake drum, and the wheel and tire
assembly.
(7) Remove the locking pliers from the front park
brake cable. This will automatically adjust the park
brake cables.
(8) Apply and release park brake pedal 1 time,
this will seat the park brake cables.
LEFT REAR PARK BRAKE CABLE
REMOVE
(1) Raise vehicle on jackstands or centered on a
hoist. See Hoisting in the Lubrication and Mainte-
nance group of this service manual.
(2) Remove rear tire and wheel assembly.
BRAKES 5 - 67