Chrysler 1998 Voyager Service Manual page 22

0 - 6 LUBRICATION AND MAINTENANCE
GENERAL INFORMATION (Continued)
• Replace spark plugs.
• Replace ignition cables.
• Inspect serpentine drive belt, replace if neces-
sary. This maintenance is not required if belt was
previously replaced.
• Drain and refill automatic transaxle fluid and
replace filter. Adjust band, if so equipped. (See note)
• Change AWD power transfer unit fluid.
78,000 Miles (125 000 km)
• Change engine oil.
• Replace engine oil filter.
81,000 Miles (130 000 km)
• Change engine oil.
• Inspect brake linings.
• Flush and replace engine coolant.
84,000 Miles (134 000 km)
• Change engine oil.
• Replace engine oil filter.
• Change AWD overrunning clutch and rear car-
rier fluid.
87,000 Miles (139 000 km)
• Change engine oil.
90,000 Miles (144 000 km)
• Change engine oil.
• Replace engine oil filter.
• Replace air cleaner element.
• Check PCV valve and replace if necessary.
Not required if previously changed. *
• Inspect serpentine drive belt, replace if neces-
sary. This maintenance is not required if belt was
previously replaced.
• Drain and refill automatic transmission fluid
and replace filter. Adjust bands, if so equipped. (See
note)
• Change AWD power transfer unit fluid.
• Inspect tie rod ends and boot seals.
• Inspect brake linings.
93,000 Miles (149 000 km)
• Change engine oil.
96,000 Miles (154 000 km)
• Change engine oil.
• Replace engine oil filter.
99,000 Miles (158 000 km)
• Change engine oil.
• Inspect brake linings.
102,000 Miles (163 000 km)
• Change engine oil.
• Replace engine oil filter.
105,000 Miles (168 000 km)
• Change engine oil.
• Inspect air cleaner element. Replace as
necessary.
• Inspect serpentine drive belt, replace if neces-
sary. This maintenance is not required if belt was
previously replaced.
• Drain and refill automatic transmission fluid
and filter. Adjust bands, if so equipped. (See note)
• Change AWD power transfer unit fluid.
• Change AWD overrunning clutch and rear car-
rier fluid.
108,000 Miles (173 000 km)
• Change engine oil.
• Replace engine oil filter.
• Inspect brake linings.
111,000 Miles (178 000 km)
• Change engine oil.
• Flush and replace engine coolant.
114,000 Miles (182 000 km)
• Change engine oil.
• Replace engine oil filter.
117,000 Miles (187 000 km)
• Change engine oil.
• Inspect brake linings.
120,000 Miles (192 000 km)
• Change engine oil.
• Replace engine oil filter.
• Replace air cleaner element.
• Inspect PCV valve. Replace as necessary. *
• Inspect serpentine drive belt. Not required if
replaced at 75,000, 90,000 or 105,000 miles.
• Drain and refill automatic transmission fluid
and replace filter. Adjust bands, if so equipped.
• Change AWD power transfer unit fluid.
• Inspect tie rod ends and boot seals.
* This maintenance is recommended by Chrysler to
the owner but is not required to maintain the war-
ranty on the PCV valve.
** If California vehicle, this maintenance is recom-
mended by Chrysler to the owner but is not required
to maintain the warranty of the timing belt.
NOTE: Operating vehicle more than 50% in heavy
traffic during hot weather, above 90°F (32°C), using
vehicle for police, taxi, limousine type operation or
trailer towing require the more frequent transaxle
service noted in Schedule – B. Perform these ser-
vices if vehicle is usually operated under these con-
ditions.
Inspection and service should also be performed
anytime a malfunction is observed or suspected.
NS