Chrysler 1998 Voyager Service Manual page 186

5 - 104 BRAKES
REMOVAL AND INSTALLATION (Continued)
(8) Remove HCU and the mounting bracket as a
unit from the vehicle.
(9) Remove the 3 bolts (Fig. 29) mounting the
HCU to the mounting bracket. Separate the HCU
from the mounting bracket.
Fig. 29 HCU Mounting Bolts
(10) Unplug the pump motor wiring harness (Fig.
30) from the CAB.
Fig. 30 Pump Motor To CAB Wiring Harness
(11) Remove the 4 bolts (Fig. 31) attaching the
CAB to the valve block of the HCU.
(12) Remove the CAB from the valve block of the
HCU (Fig. 32).
INSTALL
(1) Install the CAB (Fig. 32) on the valve block of
the HCU.
(2) Install the 4 bolts mounting the CAB (Fig. 31)
to the valve block of the HCU. Tighten the CAB
mounting bolts to a torque of 2 N·m (17 in. lbs.).
(3) Plug the pump/motor wiring harness into the
CAB (Fig. 30).
Fig. 31 CAB Attaching Bolts
Fig. 32 Remove/Install CAB
(4) Install the HCU on the mounting bracket (Fig.
29). Install the 3 bolts (Fig. 29) attaching the HCU to
the mounting bracket. Tighten the 3 mounting bolts
to a torque of 11 N·m (97 in. lbs.).
CAUTION: The HCU mounting bracket to front sus-
pension cradle mounting bolts have a unique corro-
sion protection coating and a special aluminum
washer. For this reason, only the original, or origi-
nal equipment Mopar replacement bolts can be
used to mount the HCU bracket to the front suspen-
sion crossmember.
(5) Install the HCU and its mounting bracket as
an assembly on the front suspension crossmember.
Install the 3 bolts attaching the HCU bracket to the
crossmember (Fig. 28). Tighten the 3 mounting bolts
to a torque of 28 N·m (250 in. lbs.).
NS