Chrysler 1998 Voyager Service Manual page 473

NS
REMOVAL AND INSTALLATION (Continued)
DOME LAMP
REMOVAL
(1) Insert a small, flat bladed pry tool between
dome lamp lens and dome lamp body on left side of
dome lamp.
(2) Disengage left side of dome lamp lens from
lamp body (Fig. 11).
(3) Pivot dome lamp lens downward until lens
hook is clear of headlining.
(4) Slide dome lamp toward right side of vehicle
until hook on dome lamp is clear of headlining (Fig.
12).
(5) Remove dome lamp from headlining.
(6) Disconnect wire connector from dome lamp.
(7) Remove dome lamp from vehicle.
Fig. 11 Dome Lamp Lens
Fig. 12 Dome Lamp Hook
INSTALLATION
(1) Position dome lamp in vehicle.
(2) Connect wire connector to dome lamp.
(3) Position dome lamp to headlining.
(4) Position hook on dome lamp above headlining
and slide lamp toward left side of vehicle until hook
on dome lamp is fully engaged to headlining.
(5) Push upward on dome lamp until dome lamp is
tight to headlining.
(6) Pivot dome lamp lens upward. Verify that lamp
lens hook is above the headlining.
(7) Install left side of dome lamp lens to lamp
body.
DOME LAMP BULB
REMOVAL
(1) Insert a small, flat bladed pry tool between
dome lamp lens and dome lamp body on left side of
dome lamp.
(2) Disengage left side of dome lamp lens from
lamp body (Fig. 13).
(3) Pull bulb from lamp socket
Fig. 13 Dome Lamp Bulb
INSTALLATION
(1) Push bulb into lamp socket.
(2) Pivot dome lamp lens upward. Verify that lamp
lens hook is above the headlining.
(3) Engage left side of dome lamp lens to lamp
body.
FRONT DOOR COURTESY LAMP
REMOVAL
(1) Insert a trimstick between courtesy lamp hous-
ing and door trim panel (Fig. 14).
(2) Pry rear edge of housing from trim panel.
LAMPS 8L - 21