Chrysler 1998 Voyager Service Manual page 575

NS/GS
SERVICE PROCEDURES (Continued)
Fig. 17 Augat Connector Repair
Fig. 18 Using Special Tool 6932
(5) Repair or replace the connector or terminal as
necessary.
(6) When re-assembling the connector, the locking
wedge must be placed in the locked position to pre-
vent terminal push out.
TERMINAL REPLACEMENT
(1) Disconnect battery.
(2) Disconnect the connector being repaired from
its mating half. Remove connector locking wedge, if
required (Fig. 19).
(3) Remove connector locking wedge, if required
(Fig. 19).
(4) Position the connector locking finger away from
the terminal using the proper pick from special tool
kit 6680. Pull on the wire to remove the terminal
from the connector (Fig. 20) (Fig. 21).
(5) Cut the wire 6 inches from the back of the con-
nector.
(6) Remove 1 inch of insulation from the wire on
the harness side.
8W-01 GENERAL INFORMATION
bly that best matches the color wire being repaired.
remove 1 inch of insulation.
Fig. 19 Connector Locking Wedge Tab (Typical)
Fig. 20 Terminal Removal
Fig. 21 Terminal Removal Using Special Tool
(7) Select a wire from the terminal repair assem-
(8) Cut the repair wire to the proper length and
8W - 01 - 13